Quantum Superloader 3 User Manual

Chapter 4 SuperLoader Operation
Use of Magazines and Magazine Blanks
SuperLoader User’s Guide 83
4 Grasp the magazine by the handle with one hand and slide it out,
supporting it underneath with the other hand.
Install a Magazine 4 To install a magazine into the SuperLoader, use the following procedure.
To Install a Magazine: 4
1 Grasp the magazine by the handle with one hand and support it
underneath with the other hand.
2 Slide the magazine into the magazine bay until it clicks. Make sure
that you position the magazine correctly. It should slide smoothly. If
you meet resistance, verify the orientation of the magazine.
Figure 57 Installing a
Magazine
Note: Once you eject a magazine, you must fully remove it or
fully reinstall it before power off the SuperLoader.
Knob

Quantum Superloader 3 Specifications

General

Product Type	Tape Autoloader
Number of Tape Drives Installed	1
Number of Cartridge Slots	8
Tape Technology	LTO Ultrium
Data Compression Ratio	2:1
Native Capacity	12 TB
Compressed Capacity	24 TB
Interfaces	SAS
Humidity	20% to 80% non-condensing
Operating Temperature	10°C to 35°C
Supported Media	LTO-5, LTO-4