Chapter 4 SuperLoader Operation
Configurations Page
114 SuperLoader User’s Guide
The element addresses vary depending on which magazine is
configured. If
Left or Right is selected, and both magazines are
physically installed, the front panel and On-board Remote Manager
will allow user access to the other magazine, but the SCSI host will
not have access.
To set the Magazine option: 4
1 On the main menu, scroll to
Configuration, then press Enter.
2 On the
Configuration menu, scroll to Magazines, then press Enter. The
Magazine options display. A check mark appears after the currently
enabled mode.
3 Do one of the following:
• To leave the
Magazine mode unchanged, press Escape.
•To change the
Magazine configuration, scroll to the setting you
want for the SuperLoader, and then press
Enter. These settings
are
Both, Right, and Left.
The message
This will require a power cycle and an ISV configuration
change. Enter To Continue
is displayed.
• To leave the setting unchanged, press
Escape.
• To continue with the change, press
Enter. The message Please
power cycle the tape autoloader and reconfigure the ISV app.
displays.
Set the System
Time 4
The system time is displayed by the On-board Remote Manager and it is
used internally when logging events and errors (see Time Display
on
page 104).
To Next Page
Loading...
