Quantum Superloader 3 User Manual

Chapter 4 SuperLoader Operation
Diagnostics Page
124 SuperLoader User’s Guide
Diagnostics Page 4
From the Diagnostics page, you can run the loader tests.
Run Diagnostic
Tests 4
To run diagnostic tests on the SuperLoader, use the following procedure.
To Run a Diagnostic Test: 4
1 On any On-board Remote Management page, click
Diagnostics from
the banner.
2 From the
Test drop-down menu, select the diagnostic test that you
want to run.
Figure 88 Diagnostics
Page

Quantum Superloader 3 Specifications

General

Product Type	Tape Autoloader
Number of Tape Drives Installed	1
Number of Cartridge Slots	8
Tape Technology	LTO Ultrium
Data Compression Ratio	2:1
Native Capacity	12 TB
Compressed Capacity	24 TB
Interfaces	SAS
Humidity	20% to 80% non-condensing
Operating Temperature	10°C to 35°C
Supported Media	LTO-5, LTO-4