Quantum Superloader 3 - Run Inventory; Set Data Compression

Chapter 4 SuperLoader Operation
Run Inventory
98 SuperLoader User’s Guide
Run Inventory 4
The SuperLoader automatically runs an inventory whenever you power
it back on or insert a magazine. An inventory checks each magazine slot,
the drive, the picker, and the mailslot to determine if a cartridge is
present. If so, it also reads the bar code label, if possible. If you need to
run an inventory in addition to this, you can do so manually.
To Perform an Inventory Manually: 4
1 On the main menu, scroll to
Commands, then press Enter.
2 On the Commands submenu, scroll to
Inventory, then press Enter. The
SuperLoader scans the bar codes of all the cartridges present.
Set Data Compression 4
For the SuperLoader DLT, you can set the SuperLoader to write data to
the tape in its native (uncompressed) format or to compress it.
Flex I/O Status:
Indicates the type of Flex I/O card that is installed
Version:
Indicates the current version of the Flex I/O
firmware.
Note: No bar code labels can be read if there is a tape in the picker.
Note: This command is not available for the SuperLoader LTO.