Quantum Superloader 3 - Stop a Diagnostic Test

Chapter 6 Diagnostics
Diagnostic Tests
224 SuperLoader User’s Guide
To Enter an Administrator Password: 6
1 On the main menu, scroll to
Commands, then press Enter.
2 On the Command submenu, scroll to
Enter Password, then press
Enter.
3 On the Enter Password submenu, scroll to
Administrator, then press
Enter.
The Login screen appears with a row of asterisks. A textbox appears
above the first asterisk.
4 In the textbox, scroll to the first number of the password, then press
Enter. The textbox above the asterisk disappears and another textbox
appears above the next asterisk.
5 Repeat step 4
to enter the remaining numbers of your password.
When you have finished entering your password, the LCD displays
Submit Password below the asterisks.
6 Press
Enter to submit your password. You return to the Enter
Password
submenu.
Stop a Diagnostic
Test 6
At times you may need to stop a diagnostic test while it is in progress.
Certain diagnostic tests even require you to stop them or they run
continuously. To stop a diagnostic test while it is running, use the
Halt
Test
function. When you select Halt Test, any picker or magazine
functions complete and then the Diagnostic test is stopped.
To Perform a Halt Test from the Front Panel: 6
1 While the diagnostic test that you wish to stop is running, press
Escape. The Diagnostic submenu appears.
2 On the submenu, scroll to
Halt Test, then press Enter. User Abort
appears.
3 Press
Enter to return to the Diagnostics submenu. Refer to On-board
Remote Management for any test results.
Note: Press
Escape to backspace to a previous textbox, if
necessary.