Chapter 2 Installation and Configuration
Setting Magazines
SuperLoader User’s Guide 51
v20 Firmware and
the SuperLoader
LTO 2
The v20 autoloader firmware was written to allow ISV packages to
correctly identify the configuration of LTO-based SuperLoaders. This
firmware release does not require changing the existing versions of the
drive code. After installing v20 and configuring your SuperLoader LTO
(see Setting Magazines
), your one-magazine SuperLoader will be
identified properly by the leading ISV packages. The autoloader
firmware upgrade allows you to take advantage of lower ISV licensing
fees for single-magazine operation.
v45 Firmware and
the SuperLoader
DLT (excludes
DLT1) 2
The v45 autoloader firmware was written to allow ISV packages to
correctly identify the configuration of DLT-based SuperLoaders. This
firmware release does not require changing the existing version of the
drive code. After installing v45 and configuring your SuperLoader DLT
(excluding the SuperLoader DLT1), your one-magazine SuperLoader will
be identified properly by the leading ISV packages. The autoloader
firmware upgrade allows you to take advantage of lower ISV licensing
fees for single-magazine operation. After installing the firmware, follow
the configuration procedure outlined in Setting Magazines
.
v45 Firmware and
the SuperLoader
DLT1 2
The v45 autoloader firmware was written to allow ISV packages to
correctly identify the configuration of SuperLoader DLT1.
The autoloader and drive firmware upgrades allow you to take
advantage of lower ISV licensing fees for single-magazine operations.
After installing the firmware, follow the configuration procedure
outlined in Setting Magazines
.
Note: This firmware release requires that the drive firmware be
upgraded to v63 at the same time the SuperLoader firmware
is upgraded to v45.
To Next Page
Loading...
