Quantum Superloader 3 - Error Codes; Figure 120 Error Code Block Descriptor for Hard and Soft Event Logs; Table 37 Basic Information (Superloader) Log Fields

Appendix A Basic Information Logs
SuperLoader Logs
232 SuperLoader User’s Guide
Table 37 Basic
Information
(SuperLoader) Log
Fields
Error Codes 1 Error codes appear as 8-character strings made up of either letters or
numbers for a total of 32 bits. Figure 120
shows the block descriptor for
the error codes.
Figure 120 Error
Code Block Descriptor
for Hard and Soft
Event Logs
Field Description
Time Stamp The time the event occurred. This field helps correlate the event with a
possible application interruption. If the unit is unable to acquire the correct
time/date from the SNTP time server or the front panel, the timestamp
contains values indicating the power cycle number and the time an entry
was written relative to that power cycle, listed as power on hours (POH).
Note: The unit has no internal real time clock and requires the user to set
the time of day from the front panel or acquire time via the
network interface (SNTP).
Error Code The type of error or action to which the event is related. This field helps
identify what caused the event to occur. For specific information on the
Error Code, see the Error Code field descriptions in the following sections.
Context The event’s software register information.
Bits 31-30 Bits 29-24 Bits 23-16 Bits 16-0
Recovery Action Task ID Error Type Error Location