Quantum Superloader 3 - Figure 100 Error Code Block Descriptor for Hard and Soft Event Logs; Table 15 Error Code Field Descriptions

Chapter 5 Troubleshooting
SuperLoader Error Logs
156 SuperLoader User’s Guide
Figure 100 Error
Code Block Descriptor
for Hard and Soft
Event Logs
Table 15 describes each field in error code.
Table 15 Error Code
Field Descriptions
Bits
31-30
Bits
29-28
Bits
27-24
Bits
23-20
Bits
19-16
Bits
15-12
Bits
11-8
Bits
7-4
Bits
3-0
Recovery
Action
Task ID Error Type Error Location
Field Description
Recovery Action Defines what the SuperLoader will do based on the event that occurred.
• If the value is 0, the SuperLoader will continue operations since this is
typically a soft recoverable event, or an event that is just recording an
action for when the development team is working on enhancements.
• If the value is other than 0, then you must reboot the SuperLoader in
order to recover from the event. The reboot will happen automatically.
Task ID: Defines what firmware task was being performed at the time of the event
Task ID (in Hex)
Description
00 System Timer
01 Servo
02 Picker
03 Magazine Left
04 Magazine Right
05 Magazine Up left