Quantum Superloader 3 - Eject the Cleaning Tape

Chapter 3 Tape Cartridge Use
Tape Drive Cleaning
64 SuperLoader User’s Guide
Eject the Cleaning
Tape 3
You need to eject the cleaning tape from the SuperLoader under the
following conditions:
• If you do not want to store the cleaning tape in a magazine slot after
manually cleaning the tape drive (DLT/SDLT only)
• If the cleaning tape has expired
When the tape has been used up,
Cleaning Tape Expired appears on the
front panel LCD. If you store your cleaning tape, store a new cleaning
tape after you eject the expired one (see Manual Cleaning (DLT/SDLT
Only)).
To Eject a DLT/SDLT Cleaning Tape
(on Libraries with Firmware prior to v45): 3
1 On the main menu, scroll to
Command, then press Enter.
2 On the Command submenu, scroll to
Cleaning Tape, then press Enter.
3 On the Cleaning Tape submenu, scroll to
Eject Cleaning Tape, then
press
Enter. The SuperLoader ejects the cleaning tape from the
mailslot.
To Eject a Cleaning Tape
(on Libraries with Firmware v45 or later): 3
1 On the main menu, scroll to
Configuration, then press Enter.
2 On the Configuration submenu, scroll to
Auto Clean, then press Enter.
This deselects Auto Clean and causes the cleaning tape to be ejected.