Quantum Superloader 3 - View Firmware Version; View Element Status; Figure 65 Firmware Version Display; Table 7 Firmware Version Description

Chapter 4 SuperLoader Operation
View Status Information
92 SuperLoader User’s Guide
View Firmware
Version 4
To view the current firmware version, use the following procedure.
To View the Firmware Version: 4
1 On the main menu, scroll to
Status, then press Enter.
2 On the Status submenu, scroll to
Autoloader, then press Enter.
3 On the SuperLoader submenu, scroll to
Version, then press Enter. A
list of messages similar to figure 65
appears.
Figure 65 Firmware
Version Display
Table 7 describes the meaning of each message.
Table 7 Firmware
Version Description
View Element
Status 4
The element status reports the status of the magazine slots. The status
indicates whether a slot contains a cartridge or not, and which slot is
allocated as the cleaning cartridge’s slot.
Firmware
The number indicates the firmware version.
EDC
The number indicates the Error Detection Code that was
generated when the firmware was installed. The
SuperLoader uses this number to verify that the
firmware and the memory holding the firmware are
good.
HW Rev
The number indicates the hardware version.
ME Rev
The number indicates the mechanical version.
Firmware: VX.XX
EDC: 8919EE2A
HW & ME Rev: 1 1