Chapter 5 Troubleshooting
A402: Drive Error
SuperLoader User’s Guide 185
Figure 109 32-Bit
Register
Cause 5 This error could be due to one of the following:
• Items such as a dropped leader
• An error internal to the drive
01 Drive is in the Process of Loading a tape but has not entered the
calibration phase of the load
00 Drive is in the Process of Initializing (typical after power on or a
total drive reset)
POST Flags: 32-bit register to indicate the POST failure that failed. Figure 109
shows the
breakdown of the 32-bit register. The next section indicates the fields and a brief
description.
FE Fatal Error was detected
RE Reportable Error was detected
LF Last Fail Event Log contains valid information
MF Multiple Failures were detected
UI Unexpected interrupt was detected
Failing Section If not equal to 0, return drive for repair
Failing Subsection If not equal to 0, return drive for repair
Detected Error If not equal to 0, return drive to repair
31 30 29 28 27 26 24 23 16 15 8 7 0
FE RE LF MF UI Unused Failing
Section
Failing Sub-
section
Detected
Error
Field Description
To Next Page
Loading...
Need help?
General