R&S FSL STATus Subsystem
1300.2519.12 6.251 E-11
STATus:QUEStionable:SYNC:CONDition?
This command queries the contents of the CONDition section of the
STATus:QUEStionable:SYNC register. Readout does not delete the contents of the CONDition
section.
This command is available from firmware version 1.30.
Example
STAT:QUES:SYNC:COND?
Characteristics
*RST value: –
SCPI: device–specific
Mode
all
STATus:QUEStionable:SYNC:ENABle
This command sets the bits of the ENABle section of the STATus:QUEStionable:SYNC register.
The ENABle register selectively enables the individual events of the associated EVENt section
for the summary bit.
This command is available from firmware version 1.30.
Parameter
0 to 65535
Example
STAT:QUES:SYNC:ENAB 65535
Characteristics
*RST value: –
SCPI: device–specific
Mode
all
STATus:QUEStionable:SYNC:NTRansition
This command sets the edge detectors of all bits of the STATus:QUEStionable:SYNC register
from 1 to 0 for the transitions of the CONDition bit.
This command is available from firmware version 1.30.
Parameter
0 to 65535
Example
STAT:QUES:SYNC:NTR 65535
Characteristics
*RST value: –
SCPI: device–specific
Mode
all
To Next Page
Loading...
