Rohde & Schwarz R&S FSL3 - Page 1031

TRACe Subsystem R&S FSL
1300.2519.12 6.272 E-11
T
RACe<1|2>:IQ[:STATe]
This command switches the I/Q data acquisition on or off.
Note: The I/Q data acquisition is not compatible with other measurement functions. Therefore
all other measurement functions will be switched off as soon as the I/Q measurement
function is switched on. Additionally a trace display is not possible in this operating
mode. Therefore all traces are set to "BLANK".
Parameter
ON | OFF
Example
TRAC:IQ ON
Switches on I/Q data acquisition
Characteristics
*RST value: OFF
SCPI: device–specific
Mode
A–T
TRACe<1|2>:IQ:AVERage[:STATe]
The command enables averaging of the recorded I/Q data provided that I/Q data acquisition
was previously enabled with TRACe<1|2>:IQ[:STATe].
Parameter
ON | OFF
Example
TRAC:IQ ON
Switches on acquisition of I/Q data.
TRAC:IQ:AVER ON
Enables averaging of the I/Q measurement data.
TRAC:IQ:AVER:COUN 10
Selects averaging over 10 data sets.
TRAC:IQ:DATA?
Starts the measurement and reads out the averaged data.
Characteristics
*RST value: OFF
SCPI: device–specific
Mode
A–T