Rohde & Schwarz R&S FSL3 - Page 1051

CALCulate Subsystem (Analog Demodulation, K7) R&S FSL
1300.2519.12 6.292 E-11
E
xample
A
DEM ON
Switches on the analog demodulator.
CALC:FEED 'XTIM:FM:TDOM'
Switches on the FM result display.
CALC:MARK:FUNC:ADEM:FM? PPE
Q
ueries the peak value.
Characteristics
*RST value: –
SCPI: device–specific
Mode
ADEMOD
CALCulate<1|2>:MARKer:FUNCtion:ADEMod:PM[:RESult<1...6>?]
This command queries the results of PM modulation measurement of analog demodulation. The
numeric suffix (:RESult<1...6>) indicates whether trace 1, 2, 3, 4, 5 or 6 is selected. The
numeric suffixes <1|2> are irrelevant.
Parameter
PPEak Result of measurement with detector +PK
MPEak Result of measurement with detector –PK
MIDDle
Result of averaging ±PK/2
RMS Result of rms measurement
Example
ADEM ON
Switches on the analog demodulator.
CALC:FEED 'XTIM:PM:TDOM'
Switches on the FM result display.
CALC:MARK:FUNC:ADEM:PM? PPE
Queries the peak value.
Characteristics
*RST value: –
SCPI: device–specific
Mode
ADEMOD