Rohde & Schwarz R&S FSL3 - Page 1076

R&S FSL SENSe Subsystem (Analog Demodulation, K7)
1300.2519.12 6.317 E-11
Allowed values: POSitive | NEGative
The value indicated here will be ignored for <trigger source> =
IMMediate.
<offset samples> Number of samples to be used as an offset to the trigger signal.
Allowed range: –65024 to 130559 (= –64 * 1024 + 512 to 128 *
1024 – 513)
The value indicated here will be ignored for <trigger source> =
IMMediate.
<# of meas> Number of repetitions of the measurement to be executed. The
value indicated here is especially necessary for the
average/maxhold/minhold function.
Allowed range: 0 to 32767
Note: After selecting IFPower, the trigger threshold can be set with the
TRIGger<1|2>[:SEQuence]:LEVel:IFPower command.
Example
ADEM:SET 8MHz,32000,EXT,POS,–500,30
Performs a measurement at:
sample rate 8 MHz
record length 32000
trigger source EXTernal
trigger slope POSitive
offset samples –500 (500 samples before trigger occurred)
# of meas 30
Characteristics
*RST value:
sample rate 8 MHz
record length 501
trigger source IMMediate
trigger slope POSitive
offset samples 0
# of meas 0
SCPI: device–specific
Mode
ADEMOD