Rohde & Schwarz R&S FSL3 - Page 1080

R&S FSL SENSe Subsystem (Analog Demodulation, K7)
1300.2519.12 6.321 E-11
[SENSe:]ADEMod:SRATe?
This command returns the sample rate set up for the current analog demodulation
measurement.
Example
ADEM:SRAT?
Returns the current sample rate.
Characteristics
*RST value: –
SCPI: device–specific
Mode
ADEMOD
[SENSe:]ADEMod:ZOOM[:STATe]
The command enables or disables the zoom function for the analog–demodulated
measurement data. Depending on the selected measurement time and the demodulation
bandwidth, the number of recorded test points may be greater than that shown on the display.
If the zoom function is enabled, 501 test points of the result memory are displayed from the
specified start time with [SENSe:]ADEMod:ZOOM:STARt.
If the zoom function is disabled, data reduction is used to adapt the test points to the number of
points available on the display.
Parameter
ON | OFF
Example
ADEM:ZOOM ON
Switches on the zoom function
Characteristics
*RST value: OFF
SCPI: device–specific
Mode
ADEMOD