SENSe Subsystem (Analog Demodulation, K7) R&S FSL
1300.2519.12 6.322 E-11
[
SENSe:]ADEMod:ZOOM:STARt
The command selects the start time for the display of individual measured values of the analog
demodulation. The maximum possible value depends on the measurement time, which is set in
the instrument and can be queried with the [SENSe:]ADEMod:MTIMe command.
I
f the zoom function is enabled, 501 test points of the result memory are displayed from the
specified start time with [SENSe:]ADEMod:ZOOM:STARt.
Parameter
0 s to measurement time – (500 * 1/sample rate)
Example
ADEM:ZOOM ON
Switches on the zoom function
ADEM:ZOOM:STAR 500us
Sets the starting point of the display to 500 µs.
Characteristics
*RST value: 0 s
SCPI: device–specific
Mode
ADEMOD
To Next Page
Loading...
