Rohde & Schwarz R&S FSL3 - Page 1164

R&S FSL CALCulate Subsystem (SPECM, K14)
1300.2519.12 6.405 E-11
C
ALCulate<1|2>:SPECtrogram:HDEPth
This command sets the number of frames to be stored in the history buffer.
T
he numeric suffixes <1|2> are irrelevant for this command.
Parameter
282 to 20000
The maximum number of frames depends on the number of sweep points
([SENSe<1|2>:]SWEep:POINts command) and is determined as described in chapter 2,
section Spectrogram Measurement (Option K14), Maximum number of frames.
Example
CALC:SPEC ON
Activates the Spectrogram Measurement option.
CALC:SPEC:HDEP 1000
Sets 1000 as number of frames to be stored in the history buffer.
Characteristics
RST value: 3000
SCPI: device–specific
Mode
SPECM
CALCulate<1|2>:SPECtrogram:SIZE
This command changes the screen layout.
The numeric suffixes <1|2> are irrelevant for this command.
Parameter
LARGe Enlarges the spectrogram result display and scales down the spectrum analyzer
result display.
SMALl Divides the screen in two equally sized panes.
Example
CALC:SPEC ON
Activates the Spectrogram Measurement option.
CALC:SPEC:SIZE LARG
Enlarges the spectrogram result display.
Characteristics
RST value: SMAL
SCPI: device–specific
Mode
SPECM