Rohde & Schwarz R&S FSL3 - Page 1290

R&S FSL CALCulate Subsystem (Noise Figure, K30)
1300.2519.12 6.531 E-11
C
haracteristics
RST value: –
SCPI: device–specific
M
ode
NF
CALCulate:MARKer:MAXimum[:PEAK]
This command positions the marker to the current maximum value of the selected trace
(CALCulate:MARKer:TRACe command). If the marker is off, it is switched on first.
This command is an event and therefore has no *RST value and no query.
This command is available from firmware version 1.60.
Example
CALC:MARK:MAX
Positions marker 1 to the maximum of the selected trace.
Characteristics
RST value: –
SCPI: device–specific
Mode
NF
CALCulate:MARKer:MiNimum[:PEAK]
This command positions the marker to the current mininum value of the selected trace
(CALCulate:MARKer:TRACe command). If the marker is off, it is switched on first.
This command is an event and therefore has no *RST value and no query.
This command is available from firmware version 1.60.
Example
CALC:MARK:MIN
Positions marker 1 to the minimum of the selected trace.
Characteristics
RST value: –
SCPI: device–specific
Mode
NF