Rohde & Schwarz R&S FSL3 - Page 1301

FETCh Subsystem (Noise Figure, K30) R&S FSL
1300.2519.12 6.542 E-11
F
ETCh:ARRay:MEMory<1...3>:NOISe:GAIN?
This command queries the noise measurement results of the selected memory. The results are
returned as an array of up to 100 elements of noise gain results. This command produces an
error if no data is held in the selected trace memory.
This command is only a query and therefore has no *RST value.
This command is available from firmware version 1.60.
Example
INIT
Starts a new measurement, if no measurement sequence is already in progress.
CONF:ARR:MEM2 ONCE
Copies the last recorded measurement result into the memory 2.
FETC:ARR:MEM2:NOIS:GAIN?
Returns an array of 100 noise gain results from the selected memory 2.
Characteristics
RST value: –
SCPI: device–specific
Mode
NF
FETCh:ARRay:MEMory<1...3>:NOISe:TEMPerature?
This command queries the noise measurement results of the selected memory. The results are
returned as an array of up to 100 elements of noise temperature results. This command
produces an error if no data is held in the selected trace memory.
This command is only a query and therefore has no *RST value.
This command is available from firmware version 1.60.
Example
INIT
Starts a new measurement, if no measurement sequence is already in progress.
CONF:ARR:MEM2 ONCE
Copies the last recorded measurement result into the memory 2.
FETC:ARR:MEM2:NOIS:TEMP?
Returns an array of 100 noise temperature results from the selected memory 2.
Characteristics
RST value: –
SCPI: device–specific
Mode
NF