Rohde & Schwarz R&S FSL3 - Page 1302

R&S FSL FETCh Subsystem (Noise Figure, K30)
1300.2519.12 6.543 E-11
F
ETCh:ARRay:NOISE:FIGure?
This command queries the last recorded noise figure measurement results. The results are
returned as an array of up to 100 elements of noise figure results.
This command is only a query and therefore has no *RST value.
Example
FETCh:ARRay:NOISE:FIGure?
Returns an array of 100 measured elements associated with the last noise figure measurement.
Characteristics
*RST value: –
SCPI: device–specific
Mode
NF
FETCh:ARRay:NOISE:GAIN?
This command queries the last recorded noise gain measurement results. The results are
returned as an array of up to 100 elements of noise gain results.
This command is only a query and therefore has no *RST value.
Example
FETCh:ARRay:NOISE:GAIN?
Returns an array of 100 measured elements associated with the last noise gain measurement.
Characteristics
*RST value: –
SCPI: device–specific
Mode
NF
FETCh:ARRay:NOISE:TEMPerature?
This command queries the last recorded noise temperature measurement results. The results
are returned as an array of up to 100 elements of noise temperature results.
This command is only a query and therefore has no *RST value.
Example
FETCh:ARRay:NOISE:TEMPerature?
Returns an array of 100 measured elements associated with the last noise temperature
measurement.
Characteristics
*RST value: –
SCPI: device–specific
Mode
NF