CALCulate Subsystem (WCDMA, K72) R&S FSL
1300.2519.12 6.574 E-11
CALCulate<1|2>:MARKer<1...4>:FUNCtion:PCCPch
This command sets the active marker on the primary common control physical channel.
This command is an event and therefore has no *RST value and no query.
The numeric suffixes <1|2> are irrelevant for this command.
Example
CALC:MARK1:FUNC:PCCP
Sets the active marker on the primary common control physical channel.
Characteristics
RST value: –
SCPI: device–specific
Mode
WCDMA
CALCulate<1|2>:MARKer<1...4>:FUNCtion:WCDPower[:BTS]:RESult?
This command queries the measured and calculated results of the code domain power
measurement. The results are calculated from the recorded IQ data set.
This command is only a query and therefore has no *RST value.
The numeric suffixes <1|2> and <1...4> are irrelevant for this command.
Parameter
CDPabsolute channel power absolute
CDPRelative channel power relative
CERRor chip rate error
CHANnel channel number
CSLot channel slot number
EVMRms error vector magnitude RMS
FERRor frequency error in Hz
IQIMbalance I/Q imbalance
IQOFfset I/Q offset
MACCuracy composite EVM
MTYPe modulation type
PCDerror peak code domain error
PTOTal total power
RHO rho value for every slot
SRATe symbol rate
TFRame trigger to frame
TOFFset timing offset
Example
CALC:MARK:FUNC:WCDP:RES? CDP
Queries the absolute channel power.
To Next Page
Loading...
