Rohde & Schwarz R&S FSL3 - Page 1332

R&S FSL CALCulate Subsystem (WCDMA, K72)
1300.2519.12 6.573 E-11
CALCulate:MARKer Subsystem (WCDMA, K72)
The CALCulate:MARKer subsystem checks the marker functions of the instrument.
Commands of the CALCulate:MARKer Subsystem
– CALCulate<1|2>:MARKer<1...4>[:STATe]
– CALCulate<1|2>:MARKer<1...4>:AOFF
– CALCulate<1|2>:MARKer<1...4>:FUNCtion:CPICh
– CALCulate<1|2>:MARKer<1...4>:FUNCtion:PCCPch
– CALCulate<1|2>:MARKer<1...4>:FUNCtion:WCDPower[:BTS]:RESult?
– CALCulate<1|2>:MARKer<1...4>:MAXimum[:PEAK]
– CALCulate<1|2>:MARKer<1...4>:MAXimum:LEFT
– CALCulate<1|2>:MARKer<1...4>:MAXimum:NEXT
– CALCulate<1|2>:MARKer<1...4>:MAXimum:RIGHt
– CALCulate<1|2>:MARKer<1...4>:MINimum[:PEAK]
– CALCulate<1|2>:MARKer<1...4>:MINimum:LEFT
– CALCulate<1|2>:MARKer<1...4>:MINimum:NEXT
– CALCulate<1|2>:MARKer<1...4>:MINimum:RIGHt
– CALCulate<1|2>:MARKer<1...4>:X
– CALCulate<1|2>:MARKer<1...4>:Y?
CALCulate<1|2>:MARKer<1...4>[:STATe]
For details refer to "CALCulate<1|2>:MARKer<1...4>[:STATe]" on page 6.56.
CALCulate<1|2>:MARKer<1...4>:AOFF
For details refer to "CALCulate<1|2>:MARKer<1...4>:AOFF" on page 6.56.
CALCulate<1|2>:MARKer<1...4>:FUNCtion:CPICh
This command sets the active marker on the common pilot channel.
This command is an event and therefore has no *RST value and no query.
The numeric suffixes <1|2> are irrelevant for this command.
Example
CALC:MARK1:FUNC:CPIC
Sets the active marker on the common pilot channel.
Characteristics
RST value: –
SCPI: device–specific
Mode
WCDMA