Rohde & Schwarz R&S FSL3 - Page 1367

Remote Commands of the CDMA2000 BTS Analyzer Option (K82) R&S FSL
1300.2519.12 6.608 E-11
C
haracteristics
RST value: -
SCPI: device-specific
M
ode
CDMA
CONFigure:CDPower[:BTS]:CTABle:SELect
This command selects a predefined channel table.
Parameter
<'string'> = name of the channel table
Example
Refer to the example of the CONFigure:CDPower[:BTS]:CTABle[:STATe] command.
Characteristics
RST value: "RECENT"
SCPI: device-specific
Mode
CDMA
CONFigure:CDPower[:BTS]:BCLass
This command selects the band class to be used.
Parameter
0 to 15
Example
INST:SEL BC2K
Activates the CDMA2000 BTS Analyzer option
INIT:CONT OFF
Selects single sweep
CONF:CDP:BCL 1
Selects band class 1, 1900 MHz
Characteristics
RST value: 0
SCPI: device specific
Mode
CDMA