R&S FSL CALCulate:LIMit Subsystem (WiMAX, K92/K93)
1300.2519.12 6.761 E-11
Result input/output in ASCII format Description
<average Symbol Error>,
<max Symbol Error>
Down Link Mode: ppm; Up Link Mode: %
<average SS Timing>,
<maximum SS Timing >
only returned in Up Link mode
<average IQ Offset>,
<max IQ Offset>
dB or % depending on selected units (UNIT:TABLe)
Example
CALC:LIM:BURS:ALL?
All limit values are returned.
Characteristics
RST value: –
SCPI: device–specific
Mode
OFDM, OFDMA/WiBro
CALCulate<1|2>:LIMit<1...8>:BURSt:ALL:RESult?
This command returns all the limit results.
The numeric suffixes <1|2> sets the measurement window for the calculation and the suffixes
<1...8> specify the limit lines (see CALCulate<1|2>:LIMit<1...8>:FAIL? command).
This command is only a query and therefore has no *RST value.
Return values
0 PASSED
1 FAILED
The results are output as a list of result strings separated by commas. For the output order see
CALCulate<1|2>:LIMit<1...8>:BURSt:ALL command.
Example
CALC:LIM:BURS:ALL:RES?
All limit values are returned.
Characteristics
RST value: –
SCPI: device–specific
Mode
OFDM, OFDMA/WiBro
CALCulate<1|2>:LIMit<1..8>:BURSt:BERPilot[:AVERage]
This command sets the average Bit Error Rate for pilot carriers limit.
Parameter
–1000000 to 1000000 %
Example
CALC:LIM:BURS:BERP –25.0
Average Bit Error Rate for pilot carriers limit is set to –25.0 dB.
To Next Page
Loading...
