R&S FSL CALCulate:LIMit Subsystem (WiMAX, K92/K93)
1300.2519.12 6.763 E-11
C
ALCulate<1|2>:LIMit<1...8>:BURSt:BERPilot:MAXimum:RESult?
This command returns the maximum Error Vector Magnitude Limit result. This is a combined
figure that represents the pilot, data and the free carrier.
This command is only a query and therefore has no *RST value.
Return values
0 PASSED
1 FAILED
Example
CALC:LIM:BURS:EVM:ALL:MAX:RES?
Maximum EVM for all carrier limit result is returned.
Characteristics
RST value: –
SCPI: device–specific
Mode
OFDMA/WiBro
CALCulate<1|2>:LIMit<1...8>:BURSt:EVM:ALL[:AVERage]
This command sets the average Error Vector Magnitude Limit. This is a combined figure that
represents the pilot, data and the free carrier.
The numeric suffixes <1|2> sets the measurement window for the calculation and the suffixes
<1...8> specify the limit lines (see CALCulate<1|2>:LIMit<1...8>:FAIL? command).
Parameter
–1000000 to 1000000 dB or %
If no unit is specified the unit specified by the UNIT:TABLe command is used.
Example
CALC:LIM:BURS:EVM:ALL –25.0
Average EVM for all carrier limit is set to –25.0 dB.
Characteristics
RST value: –
SCPI: device–specific
Mode
OFDM, OFDMA/WiBro
CALCulate<1|2>:LIMit<1...8>:BURSt:EVM:ALL[:AVERage]:RESult?
This command returns the average Error Vector Magnitude Limit result. This is a combined
figure that represents the pilot, data and the free carrier.
The numeric suffixes <1|2> sets the measurement window for the calculation and the suffixes
<1...8> specify the limit lines (see CALCulate<1|2>:LIMit<1...8>:FAIL? command).
This command is only a query and therefore has no *RST value.
Return values
0 PASSED
1 FAILED
To Next Page
Loading...
