Rohde & Schwarz R&S FSL3 - Page 1568

R&S FSL CONFigure Subsystem (WiMAX, K92/K93)
1300.2519.12 6.809 E-11
C
ONFigure:WIMax:ZONE<1…26>:PERMbase
This command specifies the perm base which is used in the permutation equations for the
specified zone.
Parameter
0 to 31
Example
CONF:WIM:ZONE1:PERM 0
For zone 1, perm base 0 is used in the permutation equations.
Characteristics
RST value: –
SCPI: device–specific
Mode
OFDMA/WiBro
CONFigure:WIMax:ZONE<1…26>:PRBS
This command specifies a known PRBS (pseudo random binary sequence) modulated data
sequence that is in use by the DUT of the specified zone.
Parameter
0, 1, 2, 3
Example
CONF:WIM:ZONE1:PRBS 0
Sets the PRBS to 0.
Characteristics
RST value: –
SCPI: device–specific
Mode
OFDMA/WiBro
CONFigure:WIMax:ZONE<1…26>:SYMB:OFFSet
This command specifies the symbol offset associated with the specified zone. This is used to
analyze signals which contain multiple zones and allows any zone in a subframe to be set up for
analysis.
Parameter
1 to 1000
Example
CONF:WIM:ZONE1:SYMB:OFFS 0
Sets the symbol offset for zone 1 to 0.
Characteristics
RST value: –
SCPI: device–specific
Mode
OFDMA/WiBro