CONFigure Subsystem (WiMAX, K92/K93) R&S FSL
1300.2519.12 6.808 E-11
CONFigure:WIMax:ZONE<1…26>:COUNt?
This command returns the current count of the specified zone.
This command is only a query and therefore has no *RST value.
Example
CONF:WIM:ZONE1:COUN?
Returns the count of zone 1.
Characteristics
RST value: –
SCPI: device–specific
Mode
OFDMA/WiBro
CONFigure:WIMax:ZONE<1…26>:DELete
This command deletes a specific zone. If the specified zone is within a larger list of zones, then
all following zones will be shuffled down to take up the space occupied by the deleted zone.
This command is an event and therefore has no *RST value and no query.
Example
CONF:WIM:ZONE1:DEL
Deletes zone 1.
Characteristics
RST value: –
SCPI: device–specific
Mode
OFDMA/WiBro
CONFigure:WIMax:ZONE<1…26>:IDSegment
This command specifies the segment number associated with the zone. This is only valid for
PUSC zones and will have no effect on other zone types.
Parameter
0 | 1 | 2
Example
CONF:WIM:ZONE1:IDS 0
Sets the segment number for zone 1 to 0.
Characteristics
RST value: –
SCPI: device–specific
Mode
OFDMA/WiBro
To Next Page
Loading...
