R&S FSL CONFigure Subsystem (WiMAX, K92/K93)
1300.2519.12 6.807 E-11
CONFigure:WIMax:ZONE<1…26>:BURSt<1...32>:TYPE
For the specified zone and burst, this command specifies the type of burst from the protocol
layer perspective, i.e. if the burst contains signaling information or if it is just a data burst.
Parameter
FCH frame control header
DLMAP downlink map
ULMAP uplink map
DATA data burst
Example
ONF:WIM:ZONE1:BURS1:TYPE DATA
Burst 1 is a data burst.
Characteristics
RST value: –
SCPI: device–specific
Mode
OFDMA/WiBro
CONFigure:WIMax:ZONE<1…26>:CONTrol[:DATA]
This command adds a new zone. Up to 26 user zones can be defined.
New zones can only be appended to the end of the existing defined zones. For example, if 4
zones are already defined, then the suffix required to enter a new zone is 5.
Parameter
<Anal
yze>,
<T
ype>,<Se
gment
>,<Len
gth>,
<Off
set>,
<Perm
base>,
<PRBS_
ID>
with:
<Analyze> ON | OFF Specifies whether the zone is too be marked for analysis.
<Type> DLFUSC | DLPUSC | ULPUSC zone type: downlink FUSC (Fully Used Subchanneliziation)
zone, downlink PUSC (Partial Used Subchanneliziation)
zone, or uplink PUSC zone
<Segment> 0 | 1 | 2 downlink PUSC zone segment
<Length> <numeric_value> zone symbol length
<Offset> <numeric_value> zone symbol offset
<Permbase> <numeric_value> permbase to be used for channel decoding
<PRBS_ID> <numeric_value> PRBS to be used for channel decoding
For further details refer to chapter "Instrument Functions", "WiMAX, WiBro Measurements
(Options K92/K93)", Zone/Segment List description.
Example
CONF:WIM:ZONE1:CONT ON,DLFUSC,0,10,0,0,0
Adds a DL_PUSC zone with a length of 10 symbols.
Characteristics
RST value: –
SCPI: device–specific
Mode
OFDMA/WiBro
To Next Page
Loading...
