FETCh Subsystem (WiMAX, K92/K93) R&S FSL
1300.2519.12 6.826 E-11
FETCh:BURSt:TDOMain:SUBFrame?
This command returns the minimum, average and maximum subframe time domain values. The
result is returned in (ASCII) format.
This command is only a query and therefore has no *RST value.
Example
FETC:BURS:TDOM:SUBF?
Returns the minimum, average and maximum subframe time domain values.
Characteristics
RST value: –
SCPI: device–specific
Mode
OFDMA/WiBro
FETCh:BURSt:TDOMain:ZONE?
This command returns the minimum, average and maximum zone time domain values. The
result is returned in (ASCII) format.
This command is only a query and therefore has no *RST value.
Example
FETC:BURS:TDOM:ZONE?
Returns the minimum, average and maximum zone time domain values.
Characteristics
RST value: –
SCPI: device–specific
Mode
OFDMA/WiBro
FETCh:SYMBol:COUNt?
This command returns the number of symbol in each analyzed burst found in the last
measurement sweep. The results are output as a list of result strings separated by commas in
the following (ASCII) format:
<Symbols in 1st burst>,< Symbols in 2nd burst >,…, < Symbols in last burst >
This command is only a query and therefore has no *RST value.
Example
FETC:SYMB:COUN?
The calculated symbols in the analyzed bursts for the most recent measurement are returned.
Characteristics
RST value: –
SCPI: device–specific
Mode
OFDM, OFDMA/WiBro
To Next Page
Loading...
