R&S FSL FETCh Subsystem (WiMAX, K92/K93)
1300.2519.12 6.825 E-11
FETCh:BURSt:RSSi:AVERage? / FETCh:BURSt:RSSi:MAXimum? /
FETCh:BURSt:RSSi:MINimum?
This command returns the average, minimum or maximum RSSI (received signal strength
indicator) standard deviation value. This is an estimate of the total received power of the frame
preamble of the segment of the connected BS. For details on the format refer to "ASCII formats
for returned values" on page 6.817.
This command is only a query and therefore has no *RST value.
Example
FETC:BURS:RSS:MAX?
The maximum RSSI deviation value from the most recent measurement is returned.
Characteristics
RST value: –
SCPI: device–specific
Mode
OFDM, OFDMA/WiBro
FETCh:BURSt:SYMBolerror:AVERage? / FETCh:BURSt:SYMBolerror:MAXimum? /
FETCh:BURSt:SYMBolerror:MINimum?
This command returns the percentage of symbols that were outside permissible demodulation
range within a burst..
This command is only a query and therefore has no *RST value.
Example
FETC:BURS:SYMB:MAX?
The maximum number of symbols that were out of range per burst is returned.
Characteristics
RST value: –
SCPI: device–specific
Mode
OFDM, OFDMA/WiBro
FETCh:BURSt:TDOMain:PREamble?
This command returns the minimum, average and maximum preamble time domain values. The
result is returned in (ASCII) format.
This command is only a query and therefore has no *RST value.
Example
FETC:BURS:TDOM:PRE?
Returns the minimum, average and maximum preamble time domain values.
Characteristics
RST value: –
SCPI: device–specific
Mode
OFDMA/WiBro
To Next Page
Loading...
