FETCh Subsystem (WiMAX, K92/K93) R&S FSL
1300.2519.12 6.824 E-11
FETCh:BURSt:RMS:DLPReamble:AVERage? / FETCh:BURSt:RMS:DLPReamble:MAXimum? /
FETCh:BURSt:RMS:DLPReamble:MINimum?
This command returns the average, minimum or maximum RMS burst power in dBm for the
downlink preamble measured during the measurement.
This command is only a query and therefore has no *RST value.
Example
FETC:BURS:RMS:DLPR:MAX?
The maximum RMS burst power for the downlink preamble from the most recent measurement
is returned.
Characteristics
RST value: –
SCPI: device–specific
Mode
OFDM
FETCh:BURSt:RMS:PILot:AVERage? / FETCh:BURSt:RMS:PILot:MAXimum? /
FETCh:BURSt:RMS:PILot:MINimum?
This command returns the average, minimum or maximum RMS burst power in dBm for pilot
carriers measured during the measurement.
This command is only a query and therefore has no *RST value.
Example
FETC:BURS:RMS:PIL:MAX?
The maximum RMS burst power for pilot carriers from the most recent measurement is
returned.
Characteristics
RST value: –
SCPI: device–specific
Mode
OFDM
FETCh:BURSt:RSSI?
This command returns all the received signal strength indicator (RSSI) results separated by
commas. For details on the format refer to "ASCII formats for returned values" on page 6.817.
This command is only a query and therefore has no *RST value.
Example
FETC:BURS:RSSI?
The calculated RSSI results from the most recent measurement is returned.
Characteristics
RST value: –
SCPI: device–specific
Mode
OFDM, OFDMA/WiBro
To Next Page
Loading...
