SENSe Subsystem (WiMAX, K92/K93) R&S FSL
1300.2519.12 6.838 E-11
Characteristics
*RST value: ALL
SCPI: device–specific
Mode
OFDM
[SENSe:]DEMod:FORMat:BANalyze
The remote control command sets the analysis modulation format that will be assumed for the
measurement.
If the standard is IEEE 802.16e–2005 OFDMA or WiBro, this command is query only and
returns the highest detected modulation format from the last measurement sweep.
Parameter
BPSK1/2 BI–Phase shift keying (OFDM only)
QPSK1/2 Quadrature phase shift keying
QPSK3/4 Quadrature phase shift keying
16QAM1/2 Quadrature Amplitude Modulation
16QAM3/4 Quadrature Amplitude Modulation
64QAM2/3 Quadrature Amplitude Modulation
64QAM3/4 Quadrature Amplitude Modulation
Example
DEM:FORM:BAN '16QAM1/2'
Only bursts that are of the QAM16 modulation format are analyzed.
Characteristics
*RST value: 16QAM1/2
SCPI: device–specific
Mode
OFDM, OFDMA/WiBro
[SENSe:]DEMod:FORMat:BANalyze:SYMBols:EQUal
If this command is activated only bursts of equal length will take part in the PVT analysis. The
number of symbols that a burst must have in order to take part in the PVT analysis are specified
by the [SENSe:]DEMod:FORMat:BANalyze:SYMBols:MIN command.
Parameter
ON | OFF
Example
DEM:FORM:BAN:SYMB:EQU ON
Only bursts of equal length will take part in the PVT analysis.
Characteristics
*RST value: OFF
SCPI: device–specific
Mode
OFDM
To Next Page
Loading...
