R&S FSL SENSe Subsystem (WiMAX, K92/K93)
1300.2519.12 6.839 E-11
[SENSe:]DEMod:FORMat:BANalyze:SYMBols:MAX
This command specifies the maximum number of data symbols required for bursts to qualify for
measurement analysis. Only bursts with the specified number of symbols will be used in the
measurement analysis. The number of data symbols is defined as the uncoded bits including
service and tail bits.
This value will not have any immediate effect if the
[SENSe:]DEMod:FORMat:BANalyze:SYMBols:EQUal command has been set to ON. In
this case, no range of symbols is allowed and only bursts with exactly the number of symbols
specified by the [SENSe:]DEMod:FORMat:BANalyze:SYMBols:MIN command shall take
place in measurement analysis.
Parameter
1 to 2425
Example
DEM:FORM:BAN:SYMB:MAX 1300
Only bursts which contain a maximum symbol count of 1300 are analyzed.
Characteristics
*RST value: 64
SCPI: device–specific
Mode
OFDM
[SENSe:]DEMod:FORMat:BANalyze:SYMBols:MIN
This command specifies the number of data symbols required for bursts to qualify for
measurement analysis. Only bursts with the specified number of symbols will be used in the
measurement analysis. The number of data symbols is defined as the uncoded bits including
service and tail bits.
If the [SENSe:]DEMod:FORMat:BANalyze:SYMBols:EQUal command has been set to ON,
this command specifies the exact number of symbols required for a burst to take part in
measurement analysis. If the [SENSe:]DEMod:FORMat:BANalyze:SYMBols:EQUal
command is set to OFF, this command specifies the minimum number of symbols required for a
burst to take part in measurement analysis.
Parameter
1 to 2425
Example
DEM:FORM:BAN:SYMB:MIN 16
Only bursts which contain a symbol count of 16 are analyzed.
Characteristics
*RST value: 1
SCPI: device–specific
Mode
OFDM
To Next Page
Loading...
