Rohde & Schwarz R&S FSL3 - Page 1599

SENSe Subsystem (WiMAX, K92/K93) R&S FSL
1300.2519.12 6.840 E-11
[
SENSe:]FFT:OFFSet
This command specifies the FFT start offset relative to the GP centre.
Parameter
–100 to 100
Example
FFT:OFF 0
Sets the FFT start offset to 0.
Characteristics
RST value: 0
SCPI: conform
Mode
OFDMA/WiBro
[SENSe:]FREQuency:CENTer
This command defines the center frequency of the analyzer or the measuring frequency for IQ
measurements.
Characteristics
RST value: 5 GHz
For further details refer to "[SENSe<1|2>:]FREQuency:CENTer" on page 6.200.
[SENSe:]POWer:ACHannel:ACPairs
This command sets the number of adjacent channels pairs (upper and lower channel pairs).
Parameter
0 to 3
0 stands for pure channel power measurement
Example
POW:ACH:ACP 3
Sets the number of adjacent channels to 3, i.e. the adjacent channel and alternate adjacent
channels 1 and 2 are switched on.
Characteristics
RST value: –
SCPI: device–specific
Mode
OFDM, OFDMA/WiBro