R&S FSL SENSe Subsystem (WiMAX, K92/K93)
1300.2519.12 6.849 E-11
[
SENSe:]TRACking:LEVel
This command defines whether or not the measurement results should be compensated for
level.
Parameter
ON | OFF
Example
TRAC:LEV ON
Specifies that the measurement results should be compensated for level.
Characteristics
*RST value: OFF
SCPI: conform
Mode
OFDM
[SENSe:]TRACking:PHASe
This command defines whether or not the measurement results should be compensated for
phase.
Parameter
ON | OFF
Example
TRAC:PHAS ON
Specifies that the measurement results should be compensated for phase.
Characteristics
*RST value: ON
SCPI: conform
Mode
OFDM, OFDMA/WiBro
[SENSe:]TRACking:PILot
This command defines whether the measurement results should have predefined pilot tracking
or whether the tracking should be determined when the measurement is run.
Parameter
PRED Predefined pilot tracking is used.
DET Pilot tracking is determined when
the measurement is run.
Example
TRAC:PIL DET
Pilot tracking is determined when the measurement is run.
To Next Page
Loading...
