TRIGger Subsystem (WiMAX, K92/K93) R&S FSL
1300.2519.12 6.866 E-11
T
RIGger[:SEQuence]:LEVel:POWer:AUTO
This command specifies whether or not an automatic power trigger level calculation is
performed before each main measurement. The setting of this command is ignored if the setting
for the TRIGger[:SEQuence]:LEVel[:EXTernal] command is not POWer.
Parameter
ON | OFF
Example
TRIG:LEV:POW:AUTO ON
Specifies that an automatic power trigger level calculation should be performed before the start
of each main measurement.
Characteristics
*RST value: OFF
SCPI: device–specific
Mode
OFDM, OFDMA/WiBro
To Next Page
Loading...
