SCPI–Specific Error Messages R&S FSL
1300.2519.12 9.2 E-11
Error code Error text in the case of queue poll
Error explanation
–102
Syntax error
The command is invalid.
Example: The command contains block data the instrument does not accept.
–103
Invalid separator
The command contains an invalid sign instead of a separator.
Example: A semicolon is missing after the command.
–104
Data type error
The command contains an invalid value indication.
Example: ON is indicated instead of a numeric value for frequency setting.
–105
GET not allowed
A Group Execute Trigger (GET) is within a command line.
–108
Parameter not allowed
The command contains too many parameters.
Example: Command SENSe:FREQuency:CENTer permits only one frequency indication.
–109
Missing parameter
The command contains too few parameters.
Example: The command SENSe:FREQuency:CENTer requires a frequency indication.
–110
Command header error
The header of the command is faulty.
–111
Header separator error
The header contains an invalid separator.
Example: the header is not followed by a "White Space", "*ESE255"
–112
Program mnemonic too long
The header contains more than 12 characters.
–113
Undefined header
The header is not defined for the instrument.
Example: *XYZ is undefined for every instrument.
–114
Header suffix out of range
The header contains an invalid numeric suffix.
Example: SENSe3 does not exist in the instrument.
–120
Numeric data error
The command contains a faulty numeric parameter.
–121
Invalid character in number
A number contains an invalid character.
Example: An "A" in a decimal number or a "9" in an octal number.
–123
Exponent too large
The absolute value of the exponent is greater than 32000.
–124
Too many digits
The number includes too many digits.
–128
Numeric data not allowed
The command includes a number which is not allowed at this position.
Example: The command INPut:COUPling requires indication of a text parameter.
–130
Suffix error
The command contains a faulty suffix.
To Next Page
Loading...
