Changing Settings via Markers – MKR–> Key R&S FSL
1300.2519.12 4.68 E-11
Effect of different peak excursion settings (example)
The following figure shows a trace to be examined.
Fig. 4-7: Trace example
The following table lists the signals as indicated by the marker numbers in the diagram above, as well
as the minimum of the amplitude decrease to both sides of the signal:
signal # min. amplitude decrease to both sides of the signal
1 30 dB
2 29.85 dB
3 7 dB
4 7 dB
The detected signals and their order are different depending on the peak excursion setting and the peak
search method (whether the next lower maximum or the next relative maximum are searched). The
following results are obtained. All tests start with the marker set to signal 1 by pressing the softkey
Peak.
To Next Page
Loading...
