Analog Demodulation (Option K7) R&S FSL
1300.2519.12 4.150 E-11
Z
oom
Activates or deactivates the zoom function. The zoom function is not available if the number of
measurement points falls below 501.
activated: A 1–to–1 allocation is selected, i.e. each measurement point corresponds to a
measured value. The start of the zoom window can be determined in the
associated field by entering the time.
deactivated: If more measured values than measurement points are available, several
measured values are combined in one measurement point according to the
method of the selected trace detector. For details on detectors refer to
"Detector overview" on page 4.42.
Remote: ADEM:ZOOM ON
Remote: ADEM:ZOOM:STARt 30US
Softkeys of the frequency menu (Analog Demodulation mode)
The following table shows all softkeys available in the frequency menu in Analog Demodulation mode
(FREQ key). It is possible that your instrument configuration does not provide all softkeys. If a softkey is
only available with a special option, model or (measurement) mode, this information is delivered in the
corresponding softkey description.
Menu / Command Command
Center
CF Stepsize 0.1*Span/0.1*Demod BW
0.5*Span/0.5*Demod BW
x*Span/x*Demod BW
=Center
Manual
AF Center
AF Start
AF Stop
Center
For details refer to the Center softkey in the frequency menu of the base unit.
CF Stepsize
For details refer to the CF Stepsize softkey in the frequency menu of the base unit.
0.1*Span (RF Spectrum)
For details refer to the 0.1*Span softkey in the frequency menu of the base unit.
To Next Page
Loading...
