Cable TV Measurements (Option K20) R&S FSL
1300.2519.12 4.226 E-11
Adjust Attenuation
Adjusts the input attenuator. For details on the adjustment procedure refer to "Attenuation
adjustment" on page 4.211.
Remote: POW:ACH:PRES:RLEV
Softkeys of the frequency menu (Cable TV Analyzer mode)
The following table shows all softkeys available in the frequency menu in Cable TV Analyzer mode
(FREQ key). It is possible that your instrument configuration does not provide all softkeys. If a softkey is
only available with a special option, model or (measurement) mode, this information is delivered in the
corresponding softkey description.
Menu / Command Command
RF
Channel
RF Stepsize Manual
Channel Width
Frequency Abs/Rel
RF
Opens an edit dialog box to enter the RF frequency. The interpretation of the RF frequency
depends on the signal type (analog TV or digital TV) to measure:
Signal type RF
< unused >
center frequency
analog TV vision carrier frequency
digital TV center frequency
If the modulation standard or the active measurement channel is changed, the RF is
automatically adapted.
If no channel table < none > is activated, the interpretation of the RF frequency depends on the
active measurement.
Remote: FREQ:RF 10MHZ
To Next Page
Loading...
