Cable TV Measurements (Option K20) R&S FSL
1300.2519.12 4.234 E-11
Remote: CALCulate:ATV:LIMit Subsystem, CALCulate:ATV:LIMit:RESult Subsystem,
C
ALCulate:ATV:RESult Subsystem for analog TV
Remote: CALCulate:DTV:LIMit Subsystem, CALCulate:DTV:LIMit:RESult Subsystem,
CALCulate:DTV:RESult Subsystem for digital TV
Meas Carrier
Switches the carrier or noise measurement on or off.
activate
d
Starts a new carrier measurement with the next sweep.
deactiv
ated
Starts a new noise measurement with the next sweep.
This softkey is only available in the Off–Service measurement method (setup dialog box).
Remote: CONF:ATV:CN:MEAS NOIS
Remote: CONF:ATV:CSO:MEAS NOIS
Remote: CONF:ATV:CTB:MEAS NOIS
C/N
Opens a submenu to measure the carrier–to–noise ratio.
For further information refer to "C/N – analog TV" on page 4.214.
Remote: CONF:ATV:MEAS CN
Remote: CALC:ATV:RES:CN? ALL
Reference Power
Opens a submenu to select the reference power method. The state of this submenu is not part
of the measurement parameter set. If you switch from one measurement to another, the settings
of this submenu are unchanged.
The set reference power method is indicated on the softkey:
(Meas Ch) Reference Channel softkey
(same) Same as Meas Channel softkey
<value> Manual Reference Power softkey
Remote: ATV:CN:POW:REF:MODE RCH
Remote: ATV:CSO:POW:REF:MODE RCH
Remote: ATV:CTB:POW:REF:MODE RCH
Reference Channel
Displays the active channel table to select a particular measurement channel. For further details
refer to the Channel softkey in the frequency menu.
Remote: ATV:CN:POW:REF:CHAN:MAN 5
Remote: ATV:CSO:POW:REF:CHAN:MAN 6
Remote: ATV:CTB:POW:REF:CHAN:MAN 5
To Next Page
Loading...
