Rohde & Schwarz R&S FSL3 - Page 832

R&S FSL CALCulate Subsystem
1300.2519.12 6.73 E-11
CALCulate<1|2>:MARKer<1...4>:FUNCtion:FPEaks:X?
This query reads out the list of X values of the maxima found. The number of available values
can be queried with CALCulate<1|2>:MARKer<1...4>:FUNCtion:FPEaks:COUNt?.
With sort mode X, the X values are in increasing order; with sort mode Y the order corresponds
to the decreasing order of the Y values.
The numeric suffixes <1|2> are irrelevant for this command.
This command is available from firmware version 1.30.
Example
CALC:MARK:FUNC:FPE:SORT Y
Sets the sort mode to decreasing y values
CALC:MARK:FUNC:FPE 3
Searches the 3 highest maxima for trace 1
CALC:MARK:FUNC:FPE:COUN?
Queries the number of maxima found
CALC:MARK:FPE:FUNC:X?
Queries the frequencies (span <> 0) or. time (span = 0) of the maxima found
Return values
107.5E6,153.8E6,187.9E6
frequencies in increasing order
2.05E–3,2.37E–3, 3.71e–3
times in increasing order
Characteristics
*RST value: –
SCPI: device–specific
Mode
A
CALCulate<1|2>:MARKer<1...4>:FUNCtion:FPEaks:Y?
This query reads out the list of X values of the maxima found. The number of available values
can be queried with CALCulate<1|2>:MARKer<1...4>:FUNCtion:FPEaks:COUNt?.
With sort mode X, the X values are in increasing order; with sort mode Y the order corresponds
to the decreasing order of the Y values.
The numeric suffixes <1|2> are irrelevant for this command.
This command is available from firmware version 1.30.
Example
CALC:MARK:FUNC:FPE:SORT Y
Sets the sort mode to decreasing y values
CALC:MARK:FUNC:FPE 3
Searches the 3 highest maxima for trace 1
CALC:MARK:FUNC:FPE:COUN?
Queries the number of maxima found
CALC:MARK:FUNC:FPE:Y?
Queries the levels of the maxima found
Return values
–37.5,–58.3,–59.6
level in decreasing order