Rohde & Schwarz R&S FSL3 - Page 868

R&S FSL CALCulate Subsystem
1300.2519.12 6.109 E-11
C
haracteristics
*RST value: LOG
SCPI: device–specific
M
ode
A
CALCulate<1|2>:MATH:POSition
This command defines the position of the result of the trace mathematics. The indication is in %
of the screen height, with 100% corresponding to the upper diagram border.
This command is available from firmware version 1.30.
Parameter
–100PCT to 200PCT
Example
CALC:MATH:POS 50PCT
Sets the position to the horizontal diagram center.
Characteristics
*RST value: 50PCT
SCPI: device–specific
Mode
A
CALCulate<1|2>:MATH:STATe
This command switches the mathematical relation of traces on or off.
This command is available from firmware version 1.30.
Parameter
ON | OFF
Example
CALC:MATH:STAT ON
Switches on the trace mathematics.
Characteristics
*RST value: OFF
SCPI: conform
Mode
A