Rohde & Schwarz R&S FSL3 - Page 947

SENSe Subsystem R&S FSL
1300.2519.12 6.188 E-11
[
SENSe<1|2>:]ESPectrum:BWID
This command defines the bandwidth used for measuring the channel power (reference range).
This setting takes only effect if channel power is selected as power reference type
([SENSe<1|2>:]ESPectrum:RTYPe command).
T
he numeric suffixes <1|2> are not relevant.
This command is available from firmware version 1.80.
Parameter
minimum span

value

span of reference range
Example
ESP:RTYP CPOW
Sets the power reference type to channel power.
ESP:BWID 1MHZ
Sets the Tx bandwidth to 1 MHz.
Characteristics
RST value: 3.84 MHz
SCPI: device–specific
Mode
A, CDMA, EVDO
[SENSe<1|2>:]ESPectrum:FILTer[:RRC][:STATe]
This command activates or deactivates the use of an RRC filter. This setting takes only effect if
channel power is selected as power reference type ([SENSe<1|2>:]ESPectrum:RTYPe
command).
The numeric suffixes <1|2> are not relevant.
This command is available from firmware version 1.80.
Parameter
ON | OFF
Example
ESP:RTYP CPOW
Sets the power reference type to channel power.
ESP:FILT OFF
Deactivates the use of an RRC filter.
Characteristics
RST value: ON
SCPI: device–specific
Mode
A, CDMA, EVDO