Rohde & Schwarz R&S FSL3 - Page 958

R&S FSL SENSe Subsystem
1300.2519.12 6.199 E-11
Example
ESP:RANG1:TRAN 'test'
Sets the transducer called test for range 1.
Characteristics
RST value: –
SCPI: device–specific
Mode
A, CDMA, EVDO
[SENSe<1|2>:]ESPectrum:RRANge?
This command returns the current position (number) of the reference range.
The numeric suffixes <1|2> are not relevant.
This command is only a query and therefore has no *RST value.
This command is available from firmware version 1.80.
Example
ESP:RRAN?
Returns the current position (number) of the reference range.
Characteristics
RST value: –
SCPI: device–specific
Mode
A, CDMA, EVDO
[SENSe<1|2>:]ESPectrum:RTYPe
This command sets the power reference type.
The numeric suffixes <1|2> are not relevant.
This command is available from firmware version 1.80.
Parameter
PEAK Measures the highest peak within the reference range.
CPOWer Measures the channel power within the reference range (integral bandwidth
method).
Example
ESP:RTYP PEAK
Sets the peak power reference type.
Characteristics
RST value: CPOWer
SCPI: device–specific
Mode
A, CDMA, EVDO