Rohde & Schwarz R&S FSL3 - Page 985

SENSe Subsystem R&S FSL
1300.2519.12 6.226 E-11
[SENSe<1|2>:]POWer:ACHannel:SPACing:CHANnel<1...11>
This command defines the channel spacing for the carrier signals.
The numeric suffixes <1...11> defines the TX channel. The numeric suffixes <1|2> are not
relevant.
Parameter
14 kHz to 2000 MHz
Example
POW:ACH:SPAC:CHAN 25kHz
Characteristics
*RST value: 20 kHz
SCPI: device–specific
Mode
A–F
[SENSe<1|2>:]POWer:ACHannel:TXCHannel:COUNt
This command selects the number of carrier signals.
The command is available only for multicarrier channel and adjacent–channel power
measurements with span > 0 (CALCulate<1|2>:MARKer:FUNCtion:POWer:SELect).
The numeric suffixes <1|2> are not relevant.
Parameter
1 to 12
Example
POW:ACH:TXCH:COUN 3
Characteristics
*RST value: 1
SCPI: device–specific
Mode
A
[SENSe<1|2>:]POWer:BANDwidth|BWIDth
This command defines the percentage of the power with respect to the total power. This value is
the basis for the occupied bandwidth measurement
([SENSe<1|2>:]POWer:ACHannel:PRESet).
The numeric suffixes <1|2> are not relevant.
Parameter
10 to 99.9PCT
Example
POW:BWID 95PCT