R&S FSL SENSe Subsystem
1300.2519.12 6.227 E-11
C
haracteristics
*RST value: 99PCT
SCPI: device–specific
M
ode
A–F
[SENSe<1|2>:]POWer:HSPeed
This command switches on or off the high–speed channel/adjacent channel power
measurement. The measurement itself is performed in zero span on the center frequencies of
the individual channels. The command automatically switches to zero span and back.
Depending on the selected mobile radio standard, weighting filters with
cos characteristic or
very steep–sided channel filters are used for band limitation.
The numeric suffixes <1|2> are not relevant.
Parameter
ON | OFF
Example
POW:HSP ON
Characteristics
*RST value: OFF
SCPI: device–specific
Mode
A–F
[SENSe<1|2>:]POWer:TRACe
This command assigns the channel/adjacent channel power measurement to the indicated
trace. The corresponding trace must be active, i.e. its state must be different from blank.
The numeric suffixes <1|2> are not relevant.
Note: The measurement of the occupied bandwidth (OBW) is performed on the trace on
which marker 1 is positioned. To evaluate another trace, marker 1 must be positioned to
another trace with CALCulate<1|2>:MARKer<1...4>:TRACe.
Parameter
1 to 6
Example
POW:TRAC 2
Assigns the measurement to trace 2.
Characteristics
*RST value: –
SCPI: device–specific
Mode
A
To Next Page
Loading...
