R&S FSL CALCulate Subsystem
1300.2519.12 6.63 E-11
CALCulate<1|2>:MARKer<1...4>:PEXCursion
This command defines the peak excursion, i.e. the spacing below a trace maximum which must
be attained before a new maximum is recognized, or the spacing above a trace minimum which
must be attained before a new minimum is recognized. The set value applies to all markers and
delta markers. The unit depends on the selected operating mode.
The numeric suffixes <1|2> and <1...4> are irrelevant.
Parameter
<numeric_value>
Example
CALC:MARK:PEXC 10dB
Defines peak excursion 10 dB in spectrum Spectrum Analyzer mode.
Characteristics
*RST value: 6dB in Spectrum Analyzer mode
SCPI: device–specific
Mode
A, ADEMOD, BT, CATV, SPECM
CALCulate<1|2>:MARKer<1...4>:TRACe
This command assigns the selected marker (1 to 4) to the indicated measurement curve. The
corresponding trace must be active, i.e. its status must be different from "BLANK".
If necessary the corresponding marker is switched on prior to the assignment.
The numeric suffixes <1|2> are irrelevant for this command.
Parameter
1 to 6
Example
CALC:MARK3:TRAC 2
Assigns marker 3 to trace 2.
Characteristics
*RST value: –
SCPI: device–specific
Mode
A, ADEMOD, CATV
To Next Page
Loading...
