Simrad EK15 - Checking the Transceiver and Transducer Settings

Gettingstarted
5Observethatthesubmenucloses,andthatalltextinthemenubuttonschangeto
theselectedlanguage.
Important
Toensurethatalltextsarereplacedwiththechosenlanguage,restarttheEK15
application.
Thecontextsensitiveon-linehelplemayalsobeavailableinyourlanguage.To
changethelanguageintheon-linehelp,youmustrestarttheEK15.Ifyourlanguage
isnotoffered,theEnglishon-linehelpwillappear.
Checkingthetransceiverandtransducersettings
Purpose
Thisprocedureexplainshowyoucanverifythatthetransceiverandtransducersettings
arecorrect.
Relatedtopics
•Setupmenuonpage138
•Installingafrequencychannelonpage81
•NormalOperationdialogboxonpage154
•TransceiverInstallationdialogboxonpage199
•Pulsedurationonpage279
Procedure
1Observethatthecurrentlyconnectedtransducer(s)areshownastabsontheStatus
bar.
2ClicktheSetupicon.
ThisiconislocatedundertheMainmenu.ItisusedtoopentheSetupmenu.
3ClicktheInstallationbuttontoopentheInstallationmenu.
Onthemenu,clickTransceiverInstallationtoopentheTransceiverInstallation
dialogbox.
ThepurposeoftheTransceiverInstallationdialogboxistosetupthenecessary
parameterstoconnecttheEK15computertothetransceiver(s)andthetransducer(s).
4Checkthatallapplicabletransceiversandtransducersareconnectedandoperational.
Foreachtransceiver,thisisindicatedbythegreenlabelwithtext“Installed”.
Ifaproblemexists,refertotherelevantprocedureintheOperationalprocedures
chapter.
5ClickOKtosavethecurrentsettingsandclosethedialogbox.
351718/C
25